V-green 270 User Interface Manual

Alws ya thriving on innoation, v we now er off wireless capability for vgreen® variable speed motors. Replace the plastic cover inside the terminal box (one screw).

2

Reviews (0) the vgreen® 270 variable speed motor by century is a durable tefc replacement motor designed to deliver premium energy savings from 40 percent to 80 percent versus a standard single speed motor.

V-green 270 user interface manual. Now energy conscious pool owners have an affordable replacement pump motor option that delivers the performance they demand. • ability to configure prime speed and prime duration. Remove the plastic wiring cover inside the terminal box 7.

If connected to a vgreen 270 motor, the auxiliary (aux) load on the vgreen 270 will also turn off. I assume it's probably a. Vlink® wireless motor interface offers the ability to set, adjust,

The programming flexibility offered by the vgreen. Am looking to add the vgreen 270 user interface (mounted off board) to exising vgreen 165 motor (user manual indicates this is possible), but cannot find any directions for how it should be wired anywhere on line, and, after three weeks, have not received a reply from century. The vgreen ® 270 variable speed motor offers three variable speeds, programmable from 600 to 3450 rpm, allowing users to easily identify and set the appropriate speeds to minimize energy consumption and lower the overall cost of pool ownership, all while maintaining the proper pool environment.

You’re correct that the vgreen uses the control panel speed settings but disregards the time settings when using the digital inputs. • ability to configure prime speed and prime duration. 3/8” conduit hole plug removed figure 9:

The speeds are adjusted in increments of 25 rpms. The preset speeds and schedule times are detailed in table 4. Features total enclosed fan cooling, programmable user interface and freeze sensor.

The innovative vgreen variable speed ecm offers premium efficiency boosted by such features as power factor correction, which raises overall efficiency while reducing input amps! Attach new gaskets to new terminal box cover. Ability to conduct field troubleshooting (i.e., view fault codes and real time operating parameters).

To resume normal operation, the all stop button is pressed again, turning off the led. • ability to remotely mount the vgreen 270 user interface (provides easy access of user interface depending on pump location). The digital inputs all need to be inactive with the motor stopped in order to reprogram any of the control panel speed settings, including override.

Equipped with digital inputs, the vgreen 165 variable speed motor is even compatible with third party pool automation systems. User interface and rubber gasket removed 4. Q observe all safety warnings and cautions q verify the user interface is plugged in q make certain the motor is properly wired (refer to figure 1) q turn selector knob to set clock

Freeze protection feature that can be turned on/off or adjusted. Plastic cover installed in terminal box The control interface confirms freeze control is enabled and it has worked the last couple of winters but appears to have failed this winter.

Refer to the vgreen motor user manual for dip switch positioning. Anyone know of a source that could provide this. Page 4 dip switches one and two of the vgreen motor need to be on in ® order for the automation adapter to function.

If power is connected to the vgreen 165 motor, pressing any of the following buttons referred to in section 2 could result in the motor starting. Installation and user manual stock number: 230 volt, 10.5 max amps, 1.0 service factor.

Vgreen 270 Variable Speed Pool Motor Instructions - Youtube

A.o. Smith V-Green 270 User Interface - 2520652-001 - Inyopools.com

A.o. Smith V-Green 270 User Interface - 2520652-001 - Inyopools.com

A.o. Smith V-Green 270 User Interface - 2520652-001 - Inyopools.com

2