Pro Rib Installation Guide

This guide must by read in its entirety before beginning installation. Accessories fasteners recommended tools accessories 13 dektite pipe flashing

Pro-Panel Ii® - Metal Sales

Wise, always begin flashing installation from the bottom and work up.

Pro rib installation guide. Any questions you may have regarding proper installation of the roofing system should be directed to your metal sales representative, see pages 2 and 3. Pdf (2 mb) chimney flashing instructions. This panel delivers value with high performance.

This guide is supplied by fabral, inc. Install fascia trim along all eaves and gables (rakes). Pdf (2 mb) interior liner panel.

Ms colorfast45®, colorfit40™, versa20 and acrylic coated galvalume®} corrosion protection: In less than 10 seconds on the new remote press the button you would like to code to the motor. Lap over eave trim and work upward.

6 metal sales manufacturing corporation / subject to change without notice / effective 8/19 classic rib®} finishes: Do not fasten down panels. It's environmentally friendly and manufactured to the highest industry standards.

Like step 2.1, space each end of the support board directly in the middle of each 4x4 post. Valley trim install valley trim in any valleys. Trapezoidal rib on 9 centers minimum roof slope:

On the gate, the motor move dip 1 left to on position (figure 1) and then dip 3 left to on position (figure 2). Install bottom support boards at the bottom of each post, so each support is at ground level. Az55 per astm a 792 for unpainted galvalume® az50 per astm a 792 for painted galvalume® az35 per astm a 792 for painted galvalume®.

The contents of this manual include the guidelines that were in Consult metal sales for any additional information not outlined in this manual. Fasten with wood panel screws.

Lap eave trim over any fascia trim. Eave trim install eave trim along all eaves. Use two 3 deck screws spaced evenly on each end (see fig.

Pdf (740 kb) steel siding installation. 5 rib roofing panels must be applied on a minimum roof pitch of 2½:12 or greater. For use by its customers, and is intended to be a guide only.

Pdf (4 mb) panel installation guide. Continue installing all bottom supports. Www.bestbuymetals.com “nationwide supplier of quality metal roofing.”.

5 rib installation guidelines caution: This does not replace local or Www.bestbuymetals.com “nationwide supplier of quality metal roofing.”.

All trims are 26 gauge. Remove the cover of your gate motor. Installer should be careful to seal between the gable rake or sidewall and panel with butyl sealant tape, and to fasten the rake every 6 to 12” up the slope of the roof with the.

2

How To Install 5-Rib Metal Roofing Panels On Solid Sheet Decking For Beginners - Youtube

Max-Rib Installation | Mcelroy Metal - Youtube

How To Install Metal Roofing 3Ft Panels-Asc Building Products - Youtube

Precut Pro-Rib® Steel Panel At Menards®